Here are a couple of videos of us sailing around Conwy bay in September.

A short clip sailing Tiffane off the coast of the Isle of Man

We’ve always had trouble going astern in Tiffane.  She just doesn’t respond, even stopping is very difficult.  We had the prop checked last year but it wasn’t worn or slipping.  However, it was a very small 2-bladed job, more suitable for a small petrol engine.

This year we therefore decided to replace it, but unfortunately the new one hadn’t arrived by launch day.  So this week-end we beached her and the engineer replaced it.

Beaching in Conwy river is very easy, there are so many mud banks to choose from!  As there was quite a breeze blowing (3 gusting 5 in the river, 4 gusting 6 out at sea), we went for the upwind shore – trickier to do the beaching but trivial to get her back off again.

The bad news is that although she performs better, the problem isn’t fixed.  I personally think the gearbox is slipping so that’s another job…

We launched late this year, mainly due to being pretty busy at work earlier in the year.  While she was out of the water in 2008 / 2009 we had all four chainplates replaced as one was showing signs of raising up.  We also replaced another section of the cockpit (Starboard side) where the seat support had collapsed, which involved removing the aft Starboard locker lid.  I suspect the Port one will need replacing in the next few years.

A new exhaust system and new batteries have been fitted. The electrical system is now operational and tested once again, although work in future years will include a re-wire. The cockpit floor, which was rotten all around the edges, has been replaced, and the single cockpit drain replaced with a drain on either side to improve drainage while heeling. One of the cockpit locker lids has been replaced, all the cockpit locker surrounds have been epoxied to make them watertight, the cockpit side panels have been replaced and the cockpit locker lids have had toggle catches fitted. Finally, the entire cockpit has been sanded ready for painting.

The aft bulkhead is fully fitted and painted and the galley, engine controls and battery switch are back in. A new stop cable has been fitted to the engine. The engine access hatch has been revamped, with lovely new Southco twist-catches fitted, which ensure a watertight seal around the hatch.

We discovered that the bilge pump, although operational, was literally held together with Sikaflex, and pulling at one of the hoses separated it from the pump. We discovered that the fitting had sheared from the pump and sikaflex had been used to stick it back on.

Hmmm. New bilge pump and hoses fitted, and while we were at it, a new diverter valve to select the bilge to be pumped. Couldn’t do much else this month, as we had lots of other stuff on.